Universal mats require measuring and trimming. Custom-fit mats are delivered pre-cut for the selected vehicle configuration.
For VANDECK Universal Mats
Use a fresh, sharp blade and make controlled passes rather than forcing one deep cut.
Measure cargo-floor width, length, wheel wells, and fixed obstructions before marking the mat.
Mark cut lines on the underside where practical so layout marks stay off the finished surface.
Use a rigid guide for long, clean cuts.
For VANDECK™ Custom-Fit Mats
Cold shipping may cause temporary curl. Let the rubber relax flat at room temperature before cutting.
Work gloves help with handling and protect hands while cutting and positioning heavy rubber.
Measure cargo floor width (between wheel wells), floor length (cab to rear door), and the size of each wheel well protrusion. Write these down before cutting.
Unroll the mat on a flat, clean surface and allow 30 minutes to an hour to relax, especially in cold conditions. Cutting a curled mat produces inaccurate results.
Mark the overall mat size (floor width + 1/2" each side for any variance), and mark the wheel well cutout positions from your measurements. Mark on the underside using chalk or a marker.
Use a fresh blade and a metal straight edge. Score the mat with firm pressure — it may take 2–3 passes through the full 4mm thickness. Cut on a sacrificial surface (cardboard or plywood).
Lay the mat in place. The rubber weight holds the mat without adhesive. For high-activity environments, you can use double-sided carpet tape along the edges to prevent shifting.
Custom-fit VanDeck flooring removes most of the measuring and cutting work. Confirm the vehicle configuration before ordering, then install the pre-cut mat.
Verify make, model, year range, and wheelbase before ordering so the CAD-cut mat matches the intended van.
Lay the mat flat and allow it to relax before installation, especially after cold-weather shipping.
Place the mat in the cargo area, align pre-cut contours, and reinstall trim or hardware removed for access.
Maintenance
Sweep or vacuum loose dirt, grit, and jobsite debris.
Wipe, mop, or rinse with mild soap and water as needed.
Clean spills promptly and test stronger cleaners in an inconspicuous area first.
Avoid solvents or chemicals that may attack rubber; follow vehicle and cleaner instructions.
Start with your van make, then select the correct wheelbase and surface pattern on the Custom Fit collection.
Practical answers for choosing, sizing, ordering, and installing VanDeck cargo-van flooring.
Use the Size Guide, compare fit types, or request help with a fleet or commercial order.
Custom Fit mats are CAD-cut for the selected vehicle configuration and are intended to minimize major trimming. Always dry-fit first because aftermarket interiors or accessories can affect final fit.
A tape measure, marker or chalk, rigid straight edge, sharp utility knife, and work gloves are the core tools for most trim-to-fit installations.
Most installations rely on the weight and fit of the rubber mat. If additional retention is needed for a specific use, use a method compatible with the van and keep factory service and safety points accessible.
Sweep or vacuum loose debris and clean with mild soap and water as needed. Clean oil or grease promptly and avoid solvents or chemicals that may attack rubber.
Get the VanDeck floor you need, then use this guide to complete a clean universal or custom-fit installation.
